BLOW TORCH
Inquiry    Recommend



Perfect combustion results in high heat efficiency and it is available for working in a small space such as piping, wiring and other heating. There are various kinds of torch lamps depending on fuels like butane gas, LPG, gasoline, petroleum etc.



Torch lamp for gasoline(STL - 32) : 1 Liter(fuel input)
Torch lamp for petroleum(STL - 31) : 2 Liter(fuel input)





THAILAND(BANGKOK), INDONESIA, PHILIPPINES & OTHER





209-11, Jang-dong, Dalseo-gu, Taegu, Korea
TEL. 82-53-581-7781~6
FAX. 82-53-583-2188

1. Manual
	Refuel
	1) Remove air in the tank with safety bolt, open the oiling opening and
	   pour oil into it.
	2) Pour oil up to 80% of the capacity.

	Lighting
	1) Lock the fuel adjusting cock and oiling opening and compress the air     
          with pumps about 5 times.
	2) Fill oil about 1/2 into the preheating dish and put fire then preheat the 
	  evaporator.
	3) After preheating open the fuel adjusting cock and compress the air       
          several times when the blue fire comes out.
	
	Extinguishing 
	1) Turn the fuel adjusting cock wise.
	2) Until the evaporator gets cool, don't put any inflammables around it.

2. Caution
	1) Use the only directed fuel.
	2) When you heat it, put it on the place without wind and inflammables.
	3) Don't work with a torch lamp upside down.
	4) Be careful for it not to get reflection heat from heated materials.
	5) Compress the air on the even place.
	6) Over Pressure is dangerous, keep appropriate pressure.
		* Pump 8 - 10 times with 80% of the capacity.
		* Pump 15 times with 50 of the capacity.
	7) Don't give any impact on the torch lamp.
	
< CYBER A/S CENTER >
Symptom
	# When you can't pump and compress
	  Cause
		1. Check valve of the pump doesn't work because of not being used
		   for a long time.
		2. Leather padding is weared.
	  Solution
		1. Compress strongly 2-3 times.
		2. Replace it with new leather packing and put some grease. 
Symptom
	# When fuel injection is not possible.
	  Cause
		The nozzle is dogged.
	  Solution
		1. Un fasten the pump handle you will see a wrench and a cleaning
                needle for nozzle.
		2. Unfasten the nozzle and clean it with the cleaning needle.
		3. If the hole of the nozzle is widen, replace it with new one.
Back List Next




Homepage : http://www.samwoodj.co.kr
Company : SAMWOO INDUSTRY CO.
Phone : 82-53-581-7781
FAX : 82-53-583-2188
Address : 209-11, JANG-DONG, DALSEO-GU, DAEGU, KOREA(Zip Code: 704-190)
URL : (1)http://www.samwoodj.co.kr
(2)http://www.ec21.com/co/s/samwoodj/index.html
E-mail : samwoodj@samwoodj.co.kr